Can i paint drawer pulls

You should purchase and apply a clean metal primer to improve the paint's adhesion. Clean metal primer is available in spray cans and can be purchased from nearly any hardware store. To apply it, shake the can as indicated in the directions, and spray the entire cardboard support in long, smooth passes.

A thin layer is all that is needed, and will dry faster than a thick layer. Allow the primer to dry as per the can's directions; the primer should no longer be tacky to the touch before applying paint.

Apply paint to the metal knobs. For painting metal knobs or other hardware, you should use a metal spray paint, which is designed to adhere well to metal. For a glossy and durable finish, use a spray paint that is designated as "enamel.

Shake the can and spray the knobs in long, smooth passes. Keep the spray can moving at all times to avoid creating thick patches that may lead to drips. One coat of paint will usually be sufficient. Reinstall the metal knobs. After allowing the paint to completely dry, unscrew the knobs from the cardboard support and screw them back into your drawers.

Make sure your primer and paint are completely dry before adding another coat. You could Wait a day between coats. Also, make sure you're using the right paint for metal.

It's not the same as for wood. Plasticized paint will peel right off metal. Yes No. Not Helpful 1 Helpful 2. Yes, but you will have to experiment a little. It depends on the material you are painting, and the detail behind it. Sometimes a foam brush works better so you have fewer stroke marks left behind by the paint, but sometimes a small brush works well for details.

Not Helpful 1 Helpful 1. Include your email address to get a message when this question is answered. Refinishing or restoring a piece of furniture may leave you with metal drawer pulls that need a refresh. Spray painting drawer pulls is a quick way to renew them, but you can also paint them by hand. For a longer-lasting finish, prep the pulls before you paint.

Remove the drawer pulls and save the screws or fasteners in a small bowl or plastic bag unless you plan to replace them. Whether the pulls are metal, wood or ceramic, the preparation steps are basically the same. Clean the pulls with warm soapy water or mineral spirits and use a wire brush to remove loose paint. Zero drips, zero splatter You can see here how my set up worked:.

The gardening tool was just used to weigh down the foam a bit. This contraption made painting these SO much easier! What a great idea! Step three: Let them cure! After the last coat I made sure to give them a good 20 minutes to dry before handling them at all.

Then I moved to another spot to dry for longer. I used a cardboard box in the sun on nice days with no humidity:. Check out that beautiful finish!

On those I brought them inside and placed them over an air vent to dry. After they sat for a couple hours I was able to reinstall them, but at first I didn't tighten them against the cabinets:. We didn't use the handles and 24 hours later I fully tightened them. For the next few weeks we will use a light touch, but they are completely useable!

You just want to avoid knocking anything into them while they cure, or completely dry. When you take your time spray painting you'll get a factory finish on your "new" hardware! You can use a primer before painting as well, but this Krylon Fusion All-in-one paint is just that, all in one!

No sanding or priming is required, which is a huge time saver! In my experience, cleaning the item well and then letting it fully cure is most important. The black hardware makes such a big difference in here! We LOVE it!! Start to finish this took a few days, but by far the majority of that time was letting the hardware dry. I also did it in shifts because I only had four spots in my spray paint "station.

Both versions of the hardware are equally pretty -- but I was craving more distinction. This was such an easy and cheap transformation. Spray paint can make such a difference! I'm a HUGE fan of using black accents in a room. It's one of my favorite ways to decorate a space. I really wanted to tie in our lights and island stools:. I'm still a huge brass fan and think I always will be. We still have plenty of brass accents in here that I love. In fact, I've left the island hardware brass for a two toned look.

I may spray those eventually but love it for now. The darker cabinet hardware makes a bigger statement. Here are the basics of spray painting if you want to give it a try! Clean and dry item well any moisture will cause crackling or uneven finish. Use light, quick strokes instead of heavy, long ones. It worked great for me. This article is awesome and I will use this method to paint my furniture in few upcoming days.

Good luck with your painting project, Paramvir. I hope this works for you. Good luck with the dresser, Jenn. I have a few painting projects I've been putting off, too. Thanks, Alicia. Good luck with the dresser. I hope it turns out just the way you hope.

Such a great idea! I would have never thought to do it like that! Good luck with the dresser! What type of paint do you recommend for painting cheap wooden knobs? Thanks in advance :. Leave a Reply Cancel reply Your email address will not be published.