Door sweep which side

View the FAQs below or, if you have a different question, call The foam tubes inside the Double Draft Stop can be cut to any size. Once the tubes are back in the case, the loose ends can be folded over to accommodate narrower doors and smaller windows.

The Double Draft Stop is not rigid enough to prevent all bugs from crawling under the door. A better solution in this situation would be an Aluminum and Vinyl Door Sweep that attaches to the bottom inside of the door. The fins on the 1 in. Sweeps are fairly simple to install, take a look at the threshold video , or download the instructions.

A majority of Door Sweeps should be installed on the inside of the door, since most entry doors are "in-swinging" doors. A door sweep attached to the outside of the door would be only be used for an "out-swinging" door. A good rule of thumb: you don't want the door sweep to cross the threshold when the door is in motion.

First, soak the Vinyl Insert in a tub of warm but not hot water, with just a drop of liquid soap, for about minutes. That door had a horrible draft. Karen, had placed a towel and a dog bed over her threshold to prevent the cold air from entering from under the door.

This works if you are in a pinch, but a door sweep gives you a more permanent fix. If you look at the door bottom and see sunlight or can feel the cold air, you could probably benefit from installing a door sweep. The door sweep goes on the bottom of the door on the side that faces the outside so a seal can be made between the rubber of the sweep and your threshold on the bottom of your door frame.

Not all doors are universal. You will most likely have to trim to fit your door. As well as determine the right height to install your sweep so that it closes the gap between your door and your threshold. The vinyl of the sweep can be cut with scissors and the aluminum can be trimmed with a hacksaw. Make sure you wear gloves because the hacksaw will probable leave a rough edge. Use a file to smooth out the edge.

If you cut off a predrilled hole when you trim the door sweep, you might need to drill a new hole. Once we had the holes prepared in the door sweep we had to make holes in the door, this was slightly more complicated because I once again, did not bring my workshop with me, and Karen had a metal door.

It would have been much easier to drill into with drill bits! First, hold your door sweep in place and mark the location of the slotted holes in the sweep onto your door. Then drill pilot holes in your door. Cookies cannot be used to run programs or deliver viruses to your computer.

Cookies are uniquely assigned to you, and can only be read by a web server in the domain that issued the cookie to you. One of the primary purposes of cookies is to provide a convenience feature to save you time.

The purpose of a cookie is to tell the Web server that you have returned to a specific page. This simplifies the process of recording your personal information, such as billing addresses, shipping addresses, and so on.

When you return to the same RCR International Web site, the information you previously provided can be retrieved, so you can easily use the RCR International features that you customized. You have the ability to accept or decline cookies. Most Web browsers automatically accept cookies, but you can usually modify your browser setting to decline cookies if you prefer.

If you choose to decline cookies, you may not be able to fully experience the interactive features of the RCR International services or Web sites you visit. RCR International secures your personal information from unauthorized access, use or disclosure. RCR International secures the personally identifiable information you provide on computer servers in a controlled, secure environment, protected from unauthorized access, use or disclosure.